Pellet İşleme Tesisi Proses
(Process to make more money)
• Ahşap Malzeme: Ahşap günlüğü, Yonga, Ahşap Gövde, vs
• Moisture: 45-50% depends on the weather situation.
• Step 1: Use wood chipper(disc type/drum type) to chip into 30-50mm
• Step 2: Primary Hammer Mill (change the chips to smaller size 10-20mm)
• Step 3: Three Pass Rotary Dryer (To dry the smaller size of Wood Chips to 18% moisture )
• Step 4: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
• Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.
Straw Pelet İşleme Tesisi Proses
( Economical Feasible process)
• Hammadde: Mısır Saman, ayçiçeği saman, sorgum saman, çeltik saman, vb
• Moisture: dried natually to 25% moisture roughly
• Step 1: Use grinder(tub grinder type) to grinde into 6--125mm
• Primer Hammer Mill: Aşama 2 (10 mm daha az daha küçük boyuta boyutunu değiştirmek)
• Peletleme ve soğutma istasyonu: Adım 3 boyutu 8 mm çapında ve 20-40mm uzunluğu ayarlanabilir peletler halinde testere tozu işleyin.
EFB Pelet İşleme Tesisi Proses
(yenilik süreci)
• Hammadde: EFP
• Moisture: 50-55% depends on the previous process
• (whether EFB screw press is used)
• Step 1: Use chipper(drum type) to shorten the size into 30-50mm
• Step 2: Belt Dryer (To dry the EFB fiber to 18% moisture and oil content can be lowered down )
• Step 3: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
• Step 4: Mixer (to mix the wood saw dust with EFB fiber to lower down S Content.
• Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.
