Wood Pellet bearbetningsanläggning Process
(Process to make more money)
• Wood Material: Trä log, flis, Wood Trunk, etc
• Moisture: 45-50% depends on the weather situation.
• Step 1: Use wood chipper(disc type/drum type) to chip into 30-50mm
• Step 2: Primary Hammer Mill (change the chips to smaller size 10-20mm)
• Step 3: Three Pass Rotary Dryer (To dry the smaller size of Wood Chips to 18% moisture )
• Step 4: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
• Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.

Halm Pellet Bearbetningsanläggning Process
( Economical Feasible process)
• Råmaterial: Majs halm, halm solros, sorghum halm, paddy halm, etc
• Moisture: dried natually to 25% moisture roughly
• Step 1: Use grinder(tub grinder type) to grinde into 6--125mm
• Steg 2: Primär Hammer Mill (ändra storleken till mindre storlek mindre än 10 mm)
• Steg 3: Pellete och Cooling Station: Process sågen damm i storlek 8 mm diameter och 20-40mm justerbara längd pellets.

EFB Pellet Bearbetningsanläggning Process
(innovationsprocess)
• Råmaterial: IFB
• Moisture: 50-55% depends on the previous process
• (whether EFB screw press is used)
• Step 1: Use chipper(drum type) to shorten the size into 30-50mm
• Step 2: Belt Dryer (To dry the EFB fiber to 18% moisture and oil content can be lowered down )
• Step 3: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
• Step 4: Mixer (to mix the wood saw dust with EFB fiber to lower down S Content.
• Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.

