Дрвених пелета прераду Процес
(Process to make more money)
• Дрво Материјал: Дрво дневник, Пиљевина, Дрво трунк, итд
• Moisture: 45-50% depends on the weather situation.
• Step 1: Use wood chipper(disc type/drum type) to chip into 30-50mm
• Step 2: Primary Hammer Mill (change the chips to smaller size 10-20mm)
• Step 3: Three Pass Rotary Dryer (To dry the smaller size of Wood Chips to 18% moisture )
• Step 4: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
• Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.
Страв Пеллет Процессинг Плант Процесс
( Economical Feasible process)
• Сировина: Цорн Страв, сунцокрет слама, сирак слама, падди страв, етц
• Moisture: dried natually to 25% moisture roughly
• Step 1: Use grinder(tub grinder type) to grinde into 6--125mm
• Корак 2: Примарна Хаммер Милл (промени величину на мању величину мање од 10мм)
• Корак 3: пеллетинг и хлађење Статион: Процес пиљевина у пречнику величина 8мм и 20-40мм подесиве дужине пелета.
ЕФБ Пеллет Процессинг Плант Процесс
(иновација процес)
• Сировина: и ЕФБ
• Moisture: 50-55% depends on the previous process
• (whether EFB screw press is used)
• Step 1: Use chipper(drum type) to shorten the size into 30-50mm
• Step 2: Belt Dryer (To dry the EFB fiber to 18% moisture and oil content can be lowered down )
• Step 3: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
• Step 4: Mixer (to mix the wood saw dust with EFB fiber to lower down S Content.
• Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.
