Rapid Delivery for Truck Fenders Adjustable Mudguard Support - Continuous belt dryer – OPPS

Low temperature belt dryer capacity 1t/h (dry base/continous)

Fundamental

The machine can use eletric, gas, LPG, Coal, Biological Particles, diesel and other energy heating. The working principle is that the air heated by the heat source in the hot air stove is blown by circulation fans into the inside of the drying cabinet body so that the moisture of the product is evaporated under the heat. Evaporated under this process, the generated moist air is discharged to the outside of the device with the exhaust pipe. The machine can continuously feed and make the material run smoothly. During the material conveying process, the gap is conveyed through the intermittent mesh belt to realize the turnover of the material and reach homogeneity of the heated air on all surfaces. It can connect with other equipment to achieve continuous operation. (The following is explanation of heat pump belt dryer)

Remarks: As above image shows: drying medium(ambient air) of high moisture is transfered by circulationg fan into the hot air pump(evaporator), during this process, the temparature of ambient air is lowed and moisture is dropped down as saturated air, then the air (drying medium) of lowest moisture and temperature is transfered to the condenser (hot air pump) to heat up the air. After this, the air (drying medium) of high temperature and low moisture is blowed into the raw material to dry raw material successfully.

1.Hot air stove heating energy can be natural gas, biomass pellet, Liquefied gas, LP.

5. Heating system, temperature-controlled muti-position design and high air circulation fan can make internal heat fully dispersed in every corner of the interior. Make sure there are no dead ends. Uniform temperature, ideal for air drying and drying products. 

More Pictures: