биомаса гориво

Дрво топчиња фабрика за обработка на процесот
(Process to make more money)

  Дрво Материјал: дрво најавите, дрво чипови, Вуд Багажникот, итн
 Moisture: 45-50% depends on the weather situation.
 Step 1: Use wood chipper(disc type/drum type) to chip into 30-50mm
 Step 2: Primary Hammer Mill (change the chips to smaller size 10-20mm)
 Step 3: Three Pass Rotary Dryer (To dry the smaller size of Wood Chips to 18% moisture )
•  Step 4: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
 Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.

780

Постапка Строу топчиња фабрика за обработка
( Economical Feasible process) 

•  Суровина: Строу пченка, сончоглед слама, кинеска шеќерна трска слама, оризови слама, итн
•  Moisture: dried natually to 25% moisture roughly
•  Step 1: Use grinder(tub grinder type) to grinde into 6--125mm
•  Чекор 2: Примарен чекан мелница (промена на големината на помали големина помала од 10mm)
•  Чекор 3: Pelleting и станицата за ладење: Постапка за пила прашина во дијаметар големина 8мм и 20-40mm прилагодливи пелети должина.

79-79-

EFB топчиња фабрика за обработка Процес
(процесот на иновации)

•    Суровина: EFB
•   Moisture: 50-55% depends on the previous process
  (whether EFB screw press is used)
•  Step 1: Use chipper(drum type) to shorten the size into 30-50mm
•  Step 2: Belt Dryer (To dry the EFB fiber to 18% moisture and oil content can be lowered down )
•  Step 3: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
•  Step 4: Mixer (to mix the wood saw dust with EFB fiber to lower down S Content.
•  Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.

780
模型

Испратете ни ја вашата порака:

Напишете ја вашата порака тука и испратете ја на нас