Fungi Fuel

Processus wood pellet processui herba
(Process to make more money)

  lignum Material: Wood iniuriarum, ligno eu, ligno truncus, etc
 Moisture: 45-50% depends on the weather situation.
 Step 1: Use wood chipper(disc type/drum type) to chip into 30-50mm
 Step 2: Primary Hammer Mill (change the chips to smaller size 10-20mm)
 Step 3: Three Pass Rotary Dryer (To dry the smaller size of Wood Chips to 18% moisture )
•  Step 4: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
 Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.

780

Straw Pellet processus processui herba
( Economical Feasible process) 

•  rudis materia: nisi frumentum Straw, HELIANTHUS paleas, sorghum paleas: Paddy paleas, etc
•  Moisture: dried natually to 25% moisture roughly
•  Step 1: Use grinder(tub grinder type) to grinde into 6--125mm
•  Step II: Prima Malleus L. (minor magnitudo ad magnitudinem mutare minus quam 10mm)
•  Step III: et Pelleting Refrigerant Station in processus vidit magnitudine 8mm pulvis in diameter et longitudo 20-40mm Populus Novifacta Quotidiana obtutum.

79-79-

EFB Pellet processus processui herba
(innovation processum)

•    Cruda Material: EFB
•   Moisture: 50-55% depends on the previous process
  (whether EFB screw press is used)
•  Step 1: Use chipper(drum type) to shorten the size into 30-50mm
•  Step 2: Belt Dryer (To dry the EFB fiber to 18% moisture and oil content can be lowered down )
•  Step 3: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
•  Step 4: Mixer (to mix the wood saw dust with EFB fiber to lower down S Content.
•  Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.

780
模型

Epistulam tuam nobis mitte;

Dimitte nobis scribere Read more