Bith-chonnadh Fuel

Wood Pellet Giullachd Alùmanum Pròiseas
(Process to make more money)

  Wood Material: Wood log, Wood chips, Prìomh Wood, etc
 Moisture: 45-50% depends on the weather situation.
 Step 1: Use wood chipper(disc type/drum type) to chip into 30-50mm
 Step 2: Primary Hammer Mill (change the chips to smaller size 10-20mm)
 Step 3: Three Pass Rotary Dryer (To dry the smaller size of Wood Chips to 18% moisture )
•  Step 4: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
 Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.

780

Straw Pellet Giullachd Alùmanum Pròiseas
( Economical Feasible process) 

•  Raw Material: Corn Straw, neòinean-grèine connlach, sorghum connlach, Paddy connlach, etc
•  Moisture: dried natually to 25% moisture roughly
•  Step 1: Use grinder(tub grinder type) to grinde into 6--125mm
•  Ceum 2: Hammer Bun-Mill (atharrachadh meud nas lugha gu meud nas lugha na 10mm)
•  Ceum 3: Pelleting agus socrachadh Stèisean: pròiseas sàbh an duslach a-steach meud 8mm trast-thomhas agus 20-40mm cnapan-rèitichte dh'fhaid.

79-79-

EFB Pellet Giullachd Alùmanum Pròiseas
(ùr-ghnàthachadh phròiseas)

•    Raw Material: EFB
•   Moisture: 50-55% depends on the previous process
  (whether EFB screw press is used)
•  Step 1: Use chipper(drum type) to shorten the size into 30-50mm
•  Step 2: Belt Dryer (To dry the EFB fiber to 18% moisture and oil content can be lowered down )
•  Step 3: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
•  Step 4: Mixer (to mix the wood saw dust with EFB fiber to lower down S Content.
•  Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.

780
模型

Cuir do theachdaireachd thugainn:

Sgrìobh do teachdaireachd seo agus a chur thugainn