Próiseas Adhmaid millíní Próiseáil Plandaí
(Process to make more money)
• Ábhar Adhmad: Adhmad logáil isteach, sliseanna adhmaid, Wood trunk, etc
• Moisture: 45-50% depends on the weather situation.
• Step 1: Use wood chipper(disc type/drum type) to chip into 30-50mm
• Step 2: Primary Hammer Mill (change the chips to smaller size 10-20mm)
• Step 3: Three Pass Rotary Dryer (To dry the smaller size of Wood Chips to 18% moisture )
• Step 4: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
• Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.
Tuí millíní Próiseáil Plandaí Próiseas
( Economical Feasible process)
• Ábhar Raw: Corn Tuí, tuí lus na gréine, tuí Sorghum, tuí Paddy, etc
• Moisture: dried natually to 25% moisture roughly
• Step 1: Use grinder(tub grinder type) to grinde into 6--125mm
• Céim 2: Bunscoileanna Hammer Mill (athrú ar an méid a méid níos lú níos lú ná 10mm)
• Céim 3: millíní agus Fuarú Stáisiún: Próiseas an deannaigh chonaic i trastomhas méid 8mm agus millíní fad 20-40mm inchoigeartaithe.
EFB millíní Próiseáil Plandaí Próiseas
(phróiseas nuálaíochta)
• Ábhar Raw: EFB
• Moisture: 50-55% depends on the previous process
• (whether EFB screw press is used)
• Step 1: Use chipper(drum type) to shorten the size into 30-50mm
• Step 2: Belt Dryer (To dry the EFB fiber to 18% moisture and oil content can be lowered down )
• Step 3: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
• Step 4: Mixer (to mix the wood saw dust with EFB fiber to lower down S Content.
• Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.
