Kahoy pellet Processing Plant Process
(Process to make more money)
• Kahoy Material: Wood log, Wood chips, Kahoy Punoan, etc
• Moisture: 45-50% depends on the weather situation.
• Step 1: Use wood chipper(disc type/drum type) to chip into 30-50mm
• Step 2: Primary Hammer Mill (change the chips to smaller size 10-20mm)
• Step 3: Three Pass Rotary Dryer (To dry the smaller size of Wood Chips to 18% moisture )
• Step 4: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
• Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.
Dagami pellet Processing Plant Process
( Economical Feasible process)
• Hilaw nga Material: Corn uhot, sunflower dagami, sorghum dagami, talamnan dagami, etc
• Moisture: dried natually to 25% moisture roughly
• Step 1: Use grinder(tub grinder type) to grinde into 6--125mm
• Lakang 2: Primary Hammer Mill (usab sa gidak-on sa mas gamay nga gidak-on nga ubos pa kay 10mm)
• Lakang 3: Pelleting ug sa makapabugnaw Station: proseso sa nakita abug ngadto sa gidak-on 8mm diametro ug 20-40mm mapaigoigo gitas-on pellets.
EFB pellet Processing Plant Process
(kabag-ohan nga proseso)
• Hilaw nga Material: EFB
• Moisture: 50-55% depends on the previous process
• (whether EFB screw press is used)
• Step 1: Use chipper(drum type) to shorten the size into 30-50mm
• Step 2: Belt Dryer (To dry the EFB fiber to 18% moisture and oil content can be lowered down )
• Step 3: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
• Step 4: Mixer (to mix the wood saw dust with EFB fiber to lower down S Content.
• Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.
