La biomassa combustible

Procés de Planta de Processament de pellets de fusta
(Process to make more money)

  Material Fusta: Registre de fusta, encenalls de fusta, la fusta de l'tronc, etc.
 Moisture: 45-50% depends on the weather situation.
 Step 1: Use wood chipper(disc type/drum type) to chip into 30-50mm
 Step 2: Primary Hammer Mill (change the chips to smaller size 10-20mm)
 Step 3: Three Pass Rotary Dryer (To dry the smaller size of Wood Chips to 18% moisture )
•  Step 4: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
 Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.

780

Procés de Planta de processament de palla Pellet
( Economical Feasible process) 

•  Matèria primera: Blat de moro palla, palla de gira-sol, palla de sorgo, palla d'arròs, etc
•  Moisture: dried natually to 25% moisture roughly
•  Step 1: Use grinder(tub grinder type) to grinde into 6--125mm
•  Pas 2: Primary molí de martell (canviar la mida a una mida més petita de menys de 10 mm)
•  Pas 3: Granulació i de refredament de l'estació: processar la pols serra en diàmetre de mida de 8 mm i grànuls de longitud ajustable 20-40mm.

79-79-

Planta de processament de EFB de pellets de procés
(procés d'innovació)

•    Matèria primera: EFB
•   Moisture: 50-55% depends on the previous process
  (whether EFB screw press is used)
•  Step 1: Use chipper(drum type) to shorten the size into 30-50mm
•  Step 2: Belt Dryer (To dry the EFB fiber to 18% moisture and oil content can be lowered down )
•  Step 3: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
•  Step 4: Mixer (to mix the wood saw dust with EFB fiber to lower down S Content.
•  Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.

780
模型

Envia'ns el teu missatge:

Escriu un missatge aquí i enviar-lo a nosaltres