Wood Pellet Pogon za preradu procesa
(Process to make more money)
• Drvo Materijal: Drvo dnevnik, Piljevina, Drveni Trunk, itd
• Moisture: 45-50% depends on the weather situation.
• Step 1: Use wood chipper(disc type/drum type) to chip into 30-50mm
• Step 2: Primary Hammer Mill (change the chips to smaller size 10-20mm)
• Step 3: Three Pass Rotary Dryer (To dry the smaller size of Wood Chips to 18% moisture )
• Step 4: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
• Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.
Slame Pellet Pogon za preradu procesa
( Economical Feasible process)
• Sirovina: Kukuruz Slama, suncokreta slame, sirak slame, Paddy slame, itd
• Moisture: dried natually to 25% moisture roughly
• Step 1: Use grinder(tub grinder type) to grinde into 6--125mm
• Korak 2: Primarni Hammer Mill (promijeniti veličinu na manje veličine manje od 10mm)
• Korak 3: Peletiranje i hlađenje stanice: Proces piljevine u prečnika 8mm i 20-40 mm podesive duljine peleta.
EFB Pellet Pogon za preradu procesa
(proces inovacije)
• Sirovina: EFB
• Moisture: 50-55% depends on the previous process
• (whether EFB screw press is used)
• Step 1: Use chipper(drum type) to shorten the size into 30-50mm
• Step 2: Belt Dryer (To dry the EFB fiber to 18% moisture and oil content can be lowered down )
• Step 3: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
• Step 4: Mixer (to mix the wood saw dust with EFB fiber to lower down S Content.
• Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.
