ነፍሰ ገዳዩ ደግሞ የነዳጅ

የእንጨት የሚተኩሱ በመስራት ፋብሪካ ሂደት
(Process to make more money)

  የእንጨት ይዘት: የእንጨት ምዝግብ, የእንጨት ቺፕስ, የእንጨት ኩምቢ, ወዘተ
 Moisture: 45-50% depends on the weather situation.
 Step 1: Use wood chipper(disc type/drum type) to chip into 30-50mm
 Step 2: Primary Hammer Mill (change the chips to smaller size 10-20mm)
 Step 3: Three Pass Rotary Dryer (To dry the smaller size of Wood Chips to 18% moisture )
•  Step 4: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
 Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.

780

ጭድ የሚተኩሱ በመስራት ፋብሪካ ሂደት
( Economical Feasible process) 

•  ጥሬ ይዘት: የበቆሎ ሰንበሌጥ, አደይ አበባ ገለባ, ማሽላ ገለባ, የሩዝ ገለባ, ወዘተ
•  Moisture: dried natually to 25% moisture roughly
•  Step 1: Use grinder(tub grinder type) to grinde into 6--125mm
•  የመጀመሪያ ሀመር Mill: ደረጃ 2 (10 ሚሜ በታች አነስተኛ መጠን ያለውን መጠን መቀየር)
•  Pelleting የማቀዝቀዣ ጣቢያ: ደረጃ 3 መጠን 8 ሚሜ ዲያሜትር እና 20-40mm የሚለምደዉ ርዝመት ጠጠር ወደ መጋዝ አቧራ ማካሄድ.

79-79-

EFB የሚተኩሱ በመስራት ፋብሪካ ሂደት
(የኢኖቬሽን ሂደት)

•    ጥሬ ይዘት: EFB
•   Moisture: 50-55% depends on the previous process
  (whether EFB screw press is used)
•  Step 1: Use chipper(drum type) to shorten the size into 30-50mm
•  Step 2: Belt Dryer (To dry the EFB fiber to 18% moisture and oil content can be lowered down )
•  Step 3: Secondary Hammer Mill (To make sure the saw dust size will be lower than 5mm)
•  Step 4: Mixer (to mix the wood saw dust with EFB fiber to lower down S Content.
•  Step 5: Pelleting and Cooling Station: Process the saw dust into size 8mm diameter and 20-40mm adjustable length pellets.

780
模型

መልእክትህን ላክልን፡

እዚህ መልዕክት ይጻፉ እና ለእኛ ይላኩት